Grass Valley DMC 1000 v.12.4 - Manual (Page 172)

172 DMC 1000 Digital Media Camcorder User’s Guide (v4.0)
Chapter 14 - Maintenance
To start the update procedure, hold down the Exp. Time switch and press the Select
button.
7. The camcorder searches for available files. After a few seconds the display shows a list of
available packages and licenses (image files):
8. Select the license file that is valid for this camcorder and press the Select button.
– All licenses contained in the file that are valid for this particular camcorder are installed. You
can only install licenses that are valid.
9. After a few seconds the following message is shown:
10. Press the Select button or hold down the Exp. Time switch to restart the camcorder.
– After starting up the camcorder is ready for use with the new licensed features activated.
14.3 Black calibration
After a software update, the camcorder may indicate that black calibration is necessary. To
carry out black calibration follow these steps:
1. Switch on the camcorder and wait for the system to start.
☞
Note
☞
Note
Make sure the option switch on the viewfinder is in the Off position.
☞
Note
☞
Note
Make sure user level is set to 3 to access the black calibration menu.
2. Go to the SYSTEM > BLACK CALIB menu in the Viewfinder menu and select Start.
– On confirmation the black calibration process starts.
3. The camcorder switches off its fans and the unit starts heating up until temperature
reaches 63 °C. This may take several minutes. The following message is shown in the
viewfinder:
BLACK CALIB
WAIT FOR BLACK CALIB START
Select image using [EXP. TIME -] and [EXP. TIME +]
use [SELECT] to select and [AUTO WHITE] to abort
Package on USB: C0115
Package on CAM: C0119
License on USB: DMC_1080p_24_25_30 [Invalid]
> License on USB: Bluetooth [Valid] <
New license file handled
license is updated
Press [SELECT] or [EXP. time -] to restart camera