Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 187)

2. In the K2Config application tree view, under the K2 Media Server select the File System Server
node.
The File System Server Configuration page appears.
3. Click Check and verify that the V: drive is shared.
Next, configure K2 clients and/or other iSCSI clients on the K2 SAN.
Configuring the basic nearline K2 SAN
Work through the topics in this section sequentially to configure a non-redundant nearline (Tier 3)
K2 SAN.
Related Links
Prerequisites for initial configuration - Basic nearline K2 SAN on page 187
Defining a new K2 SAN on page 128
Configuring NH server - Part 1 on page 192
Configuring RAID on page 136
Configuring NH server - Part 2 on page 203
Prerequisites for initial configuration - Basic nearline K2 SAN
Before beginning your initial configuration, make sure the devices of the K2 SAN meet the following
prerequisites.
Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
• VLANs set up
• Trunks set up
• Power on
K2 Media Server
• Ethernet cables connected
• Fibre Channel cable connected
18 November 2010 K2 SAN Installation and Service Manual 187
Configuring and licensing the K2 SAN