Extron Electronics MAV Series - Manual (Page 20)

Installation, cont’d
MAV Series Switchers • Installation 2-4
1
6
5 4
2 3
7
Figure 2-5 — MAV 128 RCA matrix switcher
Power connection
1 AC power connector — Plug a standard IEC power cord into this connector
to connect the switcher to a 100VAC to 240VAC, 50 or 60 Hz power source.
Video input and output connections (video models only)
All video input and output connections to the MAV Series switchers are made
with female BNC connectors. Some types of video
output devices do not have BNC video output
connectors. For these cases, a suitable cable or
connector adapter is necessary between the device
output connector and the BNC input connector of
the switcher. The Extron part number for the
RCA-to-BNC adapter is 10-264-01.
2 HDTV/component video inputs — Connect HDTV, component video, RGsB,
or RsGsBs video inputs to these BNC connectors for
each input.
S-video inputs — Connect S-video inputs to these
BNC connectors for each input.
Composite video inputs — Connect composite
video inputs to these BNC connectors for each
input.
3 HDTV/component video outputs — Connect
HDTV, component video, RGsB, or RsGsBs video
outputs to these BNC connectors for each output.
S-video outputs — Connect S-video outputs to
these BNC connectors for each output.
Composite video outputs — Connect composite
video outputs to these BNC connectors for each
output.
The component video and S-video MAV Series switchers can also switch video
lower on the video food chain by using only two or one BNC(s). If switching a
different video format, ensure that the same video planes are used on the
switcher output as on the input.
The MAV Series Switchers do not alter the video signal in any way. The
signal output by the switcher is in the same format as the input.
BNC Connector RCA Connector
RCA-to-BNC Connector
Input 1
Output 1
Input 1
Output 1
Y
R-Y
B-Y
Y
C
Component HDTV video
S-video
Input 1
Output 1
MAV 168/1616
1
2
1
2
1
2
1
2
1
2
1
2