Extron Electronics MAV Series - Manual (Page 31)

3-7 MAV Series Switchers • Operation
E
Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now video input 5 tied to video output 1, output 3,
output 4, and output 8; and audio input 5 tied to audio output 3, output 4,
and output 8.
Example 3: Removing a tie from a set of video and audio ties
See figure 3-6 and figure 3-7 and the following steps for an example in which an
existing audio tie is removed from the current configuration.
1
1
2
2
3
3
4
4
5
5
6
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC VIDEO AUDIO
12
9 10 11 12 8
CONTROL I/O
13
13
14
14
15
15
16
16
INPUTS
ESC
AUDIO
A
B
5
C
LED key: = off, = on,
= flash once F
F C
8
C
4 3
Press
Press
Press
Figure 3-6 — Example 3: Selecting audio and selecting input 5
A
Press and release the Esc button. The Esc LED flashes once.
B
To select audio only for the tie, if necessary, press and release the Video and
Audio buttons until the Video LED is off and the Audio LED lights.
C
Press and release the input 5 button. The input 5 LED lights. If the steps in
Example 1 have been completed, the output 3, output 4, and output 8 LEDs
light to indicate ties created in Example 1.
The output 1 LED does not light, even if the steps in Example 2 have been
completed, because Example 2 added a video tie only.
D
Press and release the output 4 button (figure 3-7). The output 4 LED turns off,
while the output 3 and output 8 LEDs remain lit.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC VIDEO AUDIO
12
9 10 11 12 8
CONTROL I/O
13
13
14
14
15
15
16
16
AUDIO
5
LED key: = off, = on
8 3
4
D
ENTER
E
Press
Press
Figure 3-7 — Example 3, step d: Removing an audio tie
E
Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now video input 5 tied to video output 1, output 3,
output 4, and output 8; and audio input 5 tied to audio output 3 and output 8.