Extron Electronics MAV Series - Manual (Page 30)

Operation, cont’d
MAV Series Switchers • Operation 3-6
D
Press and release the output 3, output 4, and output 8 buttons. The output 3,
output 4, and output 8 LEDs blink to indicate a tentative tie.
The entire set of ties can be canceled at this point by pressing and releasing the
Esc button. The Esc LED flashes once.
1
1
2
2
3
3
4
4
5
5
6
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC VIDEO AUDIO
12
8
CONTROL I/O
13 14 15 16
9 10 11 12 13 14 15 16
4 8
INPUTS
ESC
VIDEO AUDIO
A
B
ENTER
E
3
D
5
C
F B B
LED key: = off, = on, = blinking,
= flash once F
B
B
Press
Press
Press Press Press
Press Press
Press
Figure 3-4 — Example 1: Creating a tie
E
Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now defined as video and audio input 5 tied to video
and audio output 3, output 4, and output 8.
Example 2: Adding a tie to a set of video and audio ties
See figure 3-5 and the following steps for an example in which a new video tie is
added to the current configuration.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC VIDEO AUDIO
12
8
CONTROL I/O
13 14 15 16
9 10 11 12 13 14 15 16
8
ESC
VIDEO
A
B
ENTER
E
C
1
5
C
D
C
3 4
B
B LED key: = off, = on, = blinking,
= flash once F
F
Press
Press
Press Press
Press
Figure 3-5 — Example 2: Adding a video tie
A
Press and release the Esc button. The Esc LED flashes once.
B
To select video only for the tie, if necessary, press and release the Video and
Audio buttons until the Video LED lights and the Audio LED is off.
C
Press and release the input 5 button. The input 5 LED lights. If the steps in
Example 1 have been completed, the output 3, output 4, and output 8 LEDs
light to indicate the ties created in Example 1.
D
Press and release the output 1 button. The output 1 LED blinks to indicate a
tentative tie.