Operation, cont’d, Using presets, Mav series switchers • operation 3-12 – Extron Electronics MAV Series User Manual
Page 36: Example 6: saving a preset, Example 7: recalling a preset
Operation, cont’d
MAV Series Switchers • Operation
3-12
Using presets
The current configuration (configuration 0) can be saved as a preset in any one of
16 preset memory addresses.
1.
Only the audio and video ties are stored and recalled; audio gain settings
are not saved, and they do not change when a preset is recalled.
2.
Presets cannot be viewed from the front panel unless recalled as the
current configuration. Presets can be viewed using Extron’s Windows-
based control program. See Chapter 5 for more details.
3.
The current configuration and all presets are stored in non-volatile
memory. When power is removed and restored, the current configuration
is still active and all presets are retained.
4.
When a preset is recalled, it replaces the current configuration, which is
lost unless it is also stored as a preset. The recalled preset overwrites all of
the current configuration ties in favor of the preset configuration ties.
Example 6: Saving a preset
See figure 3-13 and the following steps for an example of recalling a preset to
become the current configuration.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8
9
10
11
PRESET VIEW
ESC
VIDEO
AUDIO
12
9
10
11
12
8
CONTROL
I/O
13
13
14
14
15
15
16
16
ESC
A
1
C
B
LED key: = off, = on, = blinking,
= flash once
F
F
F
PRESET
B
B
C
Hold
Press
Press
Figure 3-13 — Example 6: Saving the current configuration as preset 1
A
Press and release the Esc button. The Esc LED flashes once.
B
Press and hold the Preset button for approximately 2 seconds until the Preset
LED begins to blink, then release the Preset button.
C
Press and release the input 1 button. The input 1 LED lights for
approximately 2 seconds and turns off. The Preset LED turns off.
Example 7: Recalling a preset
See figure 3-14 and the following steps for an example of recalling a preset to
become the current configuration.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8
9
10
11
PRESET VIEW
ESC
VIDEO
AUDIO
12
9
10
11
12
8
CONTROL
I/O
13
13
14
14
15
15
16
16
ESC
A
1
C
LED key: = off, = on,
= flash once
F
F
F
PRESET
B
C
Press
Press
Press
Figure 3-14 — Example 7: Recalling preset 1