HEIDENHAIN ND 710 v.3 - Manual (Page 23)

23
Confirm “full circle.” If req.
Bolt
H
ole
Circles/Bolt
H
ole
Circle
S
egments
Select the special functions.
SPEC
FCT
FULL CIRCLE
ENT
NUMB. HOLES
8
Enter the number of holes, e.g. 8.
Confirm with ENT.
•
•
•
CENTER Y
5 0 Y
CENTER X
X 5 0
Enter the Y coordinate of circle center,
e.g. 50 mm, confirm with ENT.
0 2
RADIUS
START ANGLE
0 3
Enter the X coordinate of circle center,
e.g. 50 mm, confirm with ENT.
Enter the radius of the bolt hole circle,
e.g. 20 mm. Confirm with ENT.
Enter the start angle for the first hole,
e.g. 30°. Confirm with ENT.
•
•
•
ENT
ENT
ENT
ENT
ENT
Select “bolt hole” circle.
SPEC
FCT
BOLT HOLE
ENT
Confirm your selection.
or
Bateil1.pm6 07.11.2001, 09:38 23