HEIDENHAIN TNC 310 (286 140) Pilot - Manual (Page 55)

5 5
Special Cycles
Special Cycles
DWELL TIME (9)
The program run is interrupted for the duration of the DWELL TIME.
CYCL DEF: Select Cycle 9 DWELL TIME
Enter the dwell time in seconds.
48 CYCL DEF 9.0 DWELL TIME
49 CYCL DEF 9.1 DWELL 0.5
PGM CALL (12)
CYCL DEF: Select Cycle 12 PGM CALL
Enter the name of the program that you wish to call
Cycle 12 PGM CALL must be called to become active.
7 CYCL DEF 12.0 PGM CALL
8 CYCL DEF 12.1 LOT31
9 L X+37.5 Y-12 R0 FMAX M99