Troubleshooting – Epson ELP-600 User Manual
Page 84
82
Tip :
• If the projector is not operating properly even though the indicators are all showing
normal, refer to "When the Indicators Provide No Help" on the following page.
• If an indicator is showing a status which does not appear in the previous tables,
contact your dealer or the nearest address provided at “International Warranty
Conditions” in Safety Instructions/World-Wide Warranty Terms included in the
package.
High-speed
cooling in
progress
(This is not an abnormality, but if the
temperature rises too high again, projection
will stop automatically.)
• Set the projector up in a place which is
well-ventilated, and so that the air inlet and
exhaust vents are clear.
• Clean the air filter.
Lamp will soon
need to be
replaced.
Have a new replacement lamp ready.
The lamp service life can become shorter than
normal as a result of the usage conditions,
and so the lamp should be replaced as soon as
possible.
* The appearance of the operation indicator
at this time will vary depending on the sta-
tus of the projector.
Standby
condition
(No abnormality)
Projection starts when the [Power] button is
pressed.
Warm-up in
progress
(No abnormality)
Wait for a short while. The indicator will stop
flashing and light with a green color.
Projecting in
progress
(No abnormality)
Cool-down in
progress
(No abnormality)
• Wait for a short while.
The cool-down
(lamp cooling operation)
period lasts for about 2 minutes. The actual
time will vary depending on the external air
temperature.
• The [Power] button will not operate during
the cool-down period. When cool-down is
complete, the indicator will stop flashing
and light orange. You can then use the
[Power] button.
Indicator status
Projector
status
Problem and remedy
Reference
page
red
orange
orange
orange
green
green
orange
Troubleshooting