7 optional block skip, Function, Inserting the “/” character – HEIDENHAIN TNC 320 (340 551-02) User Manual
Page 417: Erasing the “/” character, 7 optional bloc k skip 11.7 optional block skip
HEIDENHAIN TNC 320
417
1
1
.7 Optional Bloc
k Skip
11.7 Optional Block Skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
8
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
8
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
Inserting the “/” character
8
In the Programming and Editing mode you select the block in which
the character is to be inserted.
8
Select the HIDE BLOCK soft key.
Erasing the “/” character
8
In the Programming and Editing mode you select the block in which
the character is to be erased.
8
Select the SHOW BLOCK soft key.
This function does not work for TOOL DEF blocks.
After a power interruption the control returns to the most
recently selected setting.