HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 38)

38
D
e
fining Machining O
p
erations
Machining main group
In the Machining main group you select the following machining groups:
Machining group Soft key Page
DRILLING
Centering, drilling, reaming, boring, back
boring Page 39
THREAD
Tapping with floating tap holder, rigid tapping,
thread milling Page 50
POCKETS/STUDS
Bore milling, rectangular pockets, circular
pockets, slots, circular slots Page 65
CONTR. PGM
Run contour programs: contour train, contour
pocket roughing, fine roughing and finishing Page 77
SURFACES
Face milling Page 90