HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 89)

89
D
e
fining Machining O
p
erations
Additional parameters on the tool detail form:
8 DL: Delta length for tool T.
8 DR: Delta radius for tool T.
8 DR2: Delta radius 2 (corner radius) for tool T.
8 M function: Any miscellaneous function M.
8 Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3.
8 Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent).
Additional parameters on the milling parameters detail form:
None
Globally effective parameters on the global data detail form:
8 2nd set-up clearance