HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 81)

81
D
e
fining Machining O
p
erations
Additional parameters on the contour detail form:
8 Depth : Separately definable depths for each subcontour (FCL 2
function)
Globally effective parameters on the global data detail form:
8 Set-up clearance
8 2nd set-up clearance
8 Overlap factor
8 Retraction feed rate
8 Climb milling, or
8 Up-cut milling
„ As a rule, always start the list of subcontours with the
deepest pocket!
„ If the contour is defined as an island, the entered depth is
the island depth (with respect to the workpiece top
surface)!
„ If the depth is entered as 0, the depth defined in the
overview form is effective