HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 199)

HEIDENHAIN iTNC 530 199
7.
7 FL
OOR FINISHING (Cy
c
le 23, DIN/ISO:
G123)
Cycle parameters
 Feed rate for plunging Q11: Traversing speed of the
tool during plunging. Input range 0 to 99999.9999;
alternatively FAUTO, FU, FZ
 Feed rate for roughing Q12: Milling feed rate. Input
range 0 to 99999.9999; alternatively FAUTO, FU, FZ
 Feed rate for retraction Q208: Traversing speed of
the tool in mm/min when retracting after the
machining operation. If you enter Q208 = 0, the TNC
retracts the tool at the feed rate Q12. Input range 0 to
99999.9999; alternatively FMAX, FAUTO, PREDEF
Beispiel: NC blocks
60 CYCL DEF 23 FLOOR FINISHING
Q11=100 ;FEED RATE FOR PLNGNG
Q12=350 ;FEED RATE FOR ROUGHING
Q208=99999 ;RETRACTION FEED RATE
X
Z
Q11
Q12