HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 58)

58 Using Fixed Cycles
2.3 P
A
T
T
ERN DEF pat
ter
n definition
Entering PATTERN DEF
 Select the Programming and Editing operating mode
 Press the special functions key
 Select the functions for contour and point machining
 Open a PATTERN DEF block
 Select the desired machining pattern, e.g. a single row
 Enter the required definitions, and confirm each entry
with the ENT key
Using PATTERN DEF
As soon as you have entered a pattern definition, you can call it with
the CYCL CALL PAT function (siehe „Calling a cycle with CYCL CALL
PAT” auf Seite 49). The TNC then performs the most recently defined
machining cycle on the machining pattern you defined.
A machining pattern remains active until you define a new
one, or select a point table with the SEL PATTERN function.
You can use the mid-program startup function to select
any point at which you want to start or continue machining
(see User's Manual, Test Run and Program Run sections).