Tables and overviews 18.4 overview tables – HEIDENHAIN TNC 620 (81760x-01) ISO programming User Manual
Page 544
Tables and overviews
18.4 Overview tables
18
544
TNC 620 | User's Manual for DIN/ISO Programming | 3/2014
M
Effect
Effective at block...
Start
End
Page
M94
Reduce the rotary axis display to a value below 360°
■
"Example
NC
blocks"
M97
Machine small contour steps
■
M98
Machine open contours completely
■
M99
Blockwise cycle call
■
Cycles
Manual
M101
M102
Automatic tool change with replacement tool if maximum tool life has
expired
Reset M101
■
■
M107
M108
Suppress error message for replacement tools with oversize
Reset M107
■
■
M109
M110
M111
Constant contouring speed at cutting edge (feed rate increase and
reduction)
Constant contouring speed at cutting edge (only feed rate reduction)
Reset M109/M110
■
■
■
M116
M117
Feed rate in mm/min on rotary axes
Reset M116
■
■
M118
Superimpose handwheel positioning during program run
■
M120
Pre-calculate the radius-compensated contour (LOOK AHEAD)
■
M126
M127
Shorter-path traverse of rotary axes:
Reset M126
■
■
M128
M129
Maintaining the position of the tool tip when positioning with tilted axes
(TCPM)
Reset M128
■
■
M130
Within the positioning block: Points are referenced to the untilted
coordinate system
■
M138
Selection of tilted axes
■
M140
Retraction from the contour in the tool-axis direction
■
M143
Delete basic rotation
■
M144
M145
Compensating the machine’s kinematic configuration for ACTUAL/
NOMINAL positions at end of block
Reset M144
■
■
M141
Suppress touch probe monitoring
■
M148
M149
Automatically retract tool from the contour at an NC stop
Reset M148
■
■