HEIDENHAIN TNC 620 (81760x-01) ISO programming - Manual (Page 76)

Introduction
2.4 Status displays
2
76
TNC 620 | User's Manual for DIN/ISO Programming | 3/2014
Program section repeat/Subprograms (LBL tab)
Soft key Meaning
No direct
selection
possible
Active program section repeats with block
number, label number, and number of
programmed repeats/repeats yet to be run
Active subprogram numbers with block number
in which the subprogram was called and the
label number that was called
Information on standard cycles (CYC tab)
Soft key Meaning
No direct
selection
possible
Active machining cycle
Active values of Cycle 32 Tolerance