HEIDENHAIN TNC 640 (34059x-01) - Manual (Page 518)

518 MOD Functions
1
7.4 Set
ting the D
a
ta Int
e
rf
aces
Settings for data transfer with the TNCserver
PC software
Enter the following settings in the user parameters
(serialInterfaceRS232 / definition of data blocks for the serial
ports / RS232):
Setting the operating mode of the external
device (fileSystem)
Parameter Selection
Data transfer rate in baud Has to match the setting in
TNCserver
Data transmission protocol BLOCKWISE
Data bits in each transferred
character 7 bits
Type of parity checking EVEN
Number of stop bits 1 stop bit
Specify type of handshake: RTS_CTS
File system for file operations FE1
The functions "Transfer all files," "Transfer selected file,"
and "Transfer directory" are not available in the FE2 and
FEX modes.
External device
Operating
mode
Symbol
PC with HEIDENHAIN data transfer
software TNCremoNT LSV2
HEIDENHAIN floppy disk units FE1
Non-HEIDENHAIN devices such as
printers, scanners, punchers, PC
without TNCremoNT FEX