Energizer MMT-511 - Manual (Page 123)

Remote Control 111
3. To resume basal delivery, press and hold ACT to “wake up” the
pump. Press the S button, then press ACT. The pump will
beep/vibrate once and then will resume basal delivery.
Installing a new remote battery
The battery in the remote control needs to be changed approxi-
mately every six months, depending on how often you use the
remote.
1. Unsnap the rear panel by twisting a coin or screwdriver
between the key ring. Remove the used battery and discard
properly.
2. Insert a new A23 battery
according to the diagram
on the remote control
case. When inserting the
new battery, do not touch
any of the exposed elec-
tronics.
3. Replace the rear panel
and snap the panels together to connect remote control case.
➤ Your remote control should be able to transmit to the pump as soon as
the battery is inserted. If this does not happen:
1. Check to see if the battery is inserted properly.
2. If the battery is inserted properly and the remote control green
light does not flash, install a new battery.
➤ If the remote control does not “wake up” the pump:
1. Make sure the Easy Bolus and RF control options are turned
ON.
key ring
battery