Yaskawa DC Power Input Σ-V Series - Manual (Page 12)

E-10
Maintenance and Inspection
Disposal
• When an alarm occurs, remove the cause, reset the alarm after
confirming safety, and then resume operation.
Failure to observe this caution may result in damage to the equipment,
fire, or injury.
• Do not use the holding brake of the servomotor for braking.
Failure to observe this caution may result in malfunction.
• The servomotor will decelerate to a stop if the main-circuit or the
control-circuit power supply turns OFF during operation without
turning servo OFF.
• An alarm or warning may occur if communications are performed
with the host controller while the SigmaWin+ or Digital Operator
is operating.
If an alarm or warning occurs, it may stop the current process and stop
the system.
CAUTION
• Do not disassemble the SERVOPACK and the servomotor.
Failure to observe this caution may result in electric shock or injury.
• Do not attempt to change wiring while the power is ON.
Failure to observe this caution may result in electric shock or injury.
• When replacing the SERVOPACK, resume operation only after
copying the previous SERVOPACK parameters to the new SER-
VOPACK.
Failure to observe this caution may result in damage to the equipment.
CAUTION
• When disposing of the products, treat them as ordinary industrial
waste.
CAUTION