Yaskawa GPD515C-XXXX-CS006 - Manual (Page 4)

Change 0 4/18/97 Page 4 of 6 Doc. No. 02Y00025-0422
Change 1 9/19/00
4.3 New Program Parameters
The Traverse (Disturb) function give the drive the ability to change speed in a regular
pattern from a steady frequency reference. Traverse changes the speed of the
motor/winder so that the material being wound build up evenly.
Figure 1: Disturbed Speed Reference When Using the Traverse Function
Disturb WF Sel
Enabled
P1-01 Disturb WF Sel
Setting Range:
0 to 1
Factory Default: 1
Modbus Address: 0580H
Setting Description
0 Disturbed speed reference is disabled
1 Disturbed speed reference is enabled