Yaskawa MP2000iec - Manual (Page 29)

7 DIP Switches
YASKAWA America, Inc. MP2300iec Hardware Manual YAI-SIA-IEC-2R 29
„
SW2
Sets the Ethernet port condition and other operating conditions. The switch setting is read only when the module is first
turned ON.
Switch Switch Name State Operation Mode Default Description
S2-4 -
ON
Reserved OFF Reserved for future use
OFF
S2-3 -
ON
Reserved OFF Reserved for future use
OFF
S2-2 E-INIT
ON
Initialize Transition
Parameters for
Ethernet
OFF
When ON,
transmission
parameters such as an
IP address are set to
default at startup
(192.168.1.1.).
OFF Normal Operation
S2-1 E-TEST
ON Ethernet TEST
OFF
For self-diagnosis of
Ethernet OFF Normal Operation
• If the E-INIT switch is in the “ON” position when the controller is powered up, the IP address of the
controller will be 192.168.1.1. If the switch is in the “OFF” position at power on, then the IP address defined
in the system configuration setup will be in effect.
SW
2 E-INIT
NO
E-TEST