Yaskawa Modbus TCP/IP SI-EM3D/V User Manual
Page 22
Figure 10 Remove the NEMA Type 1 Conduit Bracket
(Models BA0001F to BA0003F and 2A0001F to 2A0006F)
8.
On models (BA0001F to BA0003F and 2A0001F to 2A0006F), the screw for the drive
ground terminal also acts as one of the screws that attaches the NEMA Type 1 conduit
bracket to the drive. Reattach the NEMA Type 1 conduit bracket according to Figure
27 and connect the drive-side of the ground wire to the drive ground terminal.
Note:
The different ground wires packaged with the option connect the option to different drive
models. Select the proper ground wire depending on drive size. Refer to
for ground wire selection by drive model.
Ground terminal
Ground wire
Drive ground terminal/
NEMA Type 1 conduit
bracket screw
Ground wire
Drive-side
connector
Screw size:
M3.5 to M6
Option unit
connector
Screw size: M3
Figure 11 Reattach the NEMA Type 1 Conduit Bracket and Connect the Ground Wire
(Models BA0001F to BA0003F and 2A0001F to 2A0006F)
5 Installation Procedure
22
YASKAWA TOEP YAICOM 17A V1000 Option Dual-Port Modbus TCP/IP SI-EM3D/V Installation Manual