Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 23)

1 Introduction
1-6
<NOTE> Other Alarm Displays
If a communications error occurs between the SERVOPACK and digital operator, the
following communications error codes are displayed. These errors may be caused by
incorrect connector connection. Check the connection and correct it. Then, turn the power
OFF and ON. If the communications error message still appears, replace the digital
operator or the SERVOPAC
K.
C P F 0 0
C O M
− E R R ( O P & S V )
C P F 0 1
C O M
− E R R ( O P & S V )