Invotel SX8800 - Manual (Page 5)

v
Operation in C1, C2 settings:
C1 and C2 use “voice activation” method, this mode of operation supports most phones or brands by
just using the Hold button but with slightly longer activation time (about 10 to 15 seconds after hold is
pressed)
In “Voice activation” mode, the device needs to hear you well therefore speak as close as
possible to the microphone, If you are on a speakerphone or using a headset speak clearly and
louder into the microphone. Be sure to read the NOTES in this section.
To activate: after you receive or make a call, you need to speak and say something before
pressing the button. Audio activates less than 15 seconds later and the corresponding L1
… L4 light on this device will start blinking.
To deactivate hold music just re-select that line and Speak Over the audio, for example say : “Hi I
am Back” , the moment the device hears it will stop the hold-music.
Note: You may also deactivate the hold-music audio by pressing the button.
NOTE1: If you hear the audio during your conversation , say something to stop the audio, this can
happen if you or your party are not talking to each other for about 7 seconds.
(after 2 times device will stop
activating audio when non speaking for the rest of the call)
NOTE2: If for any reason the hold music is playing, do not panic, simply speak over the audio to stop
it or press FLASH to stop it.
C2: If for some reason you are not able to voice activate or voice -deactivate, Hang up and set the
switch to C2 then try again using the above instructions.
Back ground Music: SX8800 can be used to provide just a back ground music during all the calls and all
the lines. In this case the device will not provide the Music-on Hold function however the same back
ground music is heard by the callers when the calls are placed on Hold.
To set the device for background music use an audio file in the SD card/USB Flash drive with soft music
and turn the volume low (counterclockwise), set the switches to C3
During the conversations the music will be heard, make sure volume is low enough to allow talking
HOLD
FLASH
P5
A B C 1 2 3
Hang up and set both to C position
and both switches to 1 position