iSys V8.5e Thermal Printer User Manual
Page 15
15
Inspect the plotter and components for any damage that may have occurred during shipment. Report any damage
to the carrier of the shipment, and to your Imaging Systems Group Inc. product representative.
Keep the box and packaging for future shipping, in the event of servicing or upgrading issues. This product must
be returned to our factory in the original or proper packaging material. Damage caused during return shipping or
due to improper packaging will not be covered by The Imaging Systems Group Inc. During shipping or storage,
place a length of thermal paper between the printhead and roller. This prevents damage caused by the two
components sticking together.
3.2
MOUNTING AND POSITIONING
Keep the V8.5e away from direct heat sources, including sunlight. Do not block the vents on the sides of the
plotter.
CAUTION: Make sure the thumbscrews are secured before operation. This is particularly important in mobile
situations. Damage to the plotter or rack components could result if the plotter becomes unstable.
VORSICHT: Versichern Sie sich vor dem Betrieb des Gerätes, dass die Flügelschrauben festgestellt sind. Das ist
besonders in beweglichen Konstellationen wichtig. Sollte der Plotter instabil werden, kann dies zu Schäden am
Plotter oder am Gestell führen.
3.3
INTERFACE SETUP
Plug the power cord into a grounded AC outlet only. Avoid sharing an outlet that is also powering other noise-
generating equipment. The V8.5e comes equipped with a Versatec short line TTL (transistor to transistor logic)
interface. This interface can be used for data cable lengths up to 50 feet.
An optional long line interface (differential) can be used for data cable lengths up to 700 feet. For optional
Centronics interface setup, see Appendix C. An external SCSI (Small Computer System Interface) is also available.
Please contact your Imaging Systems Group Inc. product representitive for further information.
3.4
MEDIA INSTALLATION
CAUTION:
Do not attempt to plot or form feed without the print medium installed. This may damage the print
head and will void the warranty.
VORSICHT:
Versuchen Sie bitte nicht, einen Druckvorgang oder Papiervorschub zu starten, wenn sich kein
Druckmedium im Plotter befindet. Dies kann zu einer Beschädigung des Druckkopfes und zum Verlust der Garantie
führen.