iSys V8.5e Thermal Printer - Manual (Page 19)

19
CAUTION: Before plotting or testing on any print media, make sure that the media setting is correct. Incorrect
settings may result in damage to the printhead and warranty. The media may also be damaged.
VORSICHT: Bevor Sie mit dem Plotten oder Testdrucken auf einem Druckmedium beginnen, versichern Sie sich,
dass die Einstellungen für das Druckmedium korrekt sind. Falsche Einstellungen können zu einer Beschädigung des
Druckkopfes und zum Verlust der Garantie führen. Außerdem kann hierdurch auch das Druckmedium beschädigt
werden.
Installing rolled film
1. Loosen the rackmount thumbscrews and pull the plotter forward on the rails.
2. Release the lid assembly by grasping underneath the black latch bar and pulling it upwards (Figure 3-5). Open
the plotter lid by lifting it straight upwards.
3. Remove the fan-fold guide by grasping the two stainless steel rails and lifting it straight upwards.
4. Place the spindle hubs onto each end of the roll of film with the spacer on the left hand side spindle.
5. Orient the roll so that the film feeds off of the top of the roll.
6. Place the roll in the plotter so that the pins on the spindle hubs snap into the slots on the spindle blocks.
7. Guide the film over the blue platen roller and under the black cutter bar as shown in Figure 3-3.
Figure 3-6 Spindle blocks