Epson SR-600 - Manual (Page 41)

Rev.A OS and Driver Setup 2-19
Developer's Guide SR-600 Confidential
Recovery Method
❏ Edit of the startup disk.
Edit the [CONFIG.SYS] and [AUTOEXEC.BAT] files created in previous section “Creation of the
recovery media” according to the device in which the image data was saved.
❏ Recovery
1. Connect the media or drive in which the data was saved in the previous section “Creation of
the recovery media” to the SR-600.
2. Use the startup FD created in the previous section “Creation of the startup disk” to reboot
the system.
3. Type "x: enter". ("x" is the drive which contains the image file).
4. Execute the [Start.bat] file.
When the title of EasyRestore appears and then the startup screen appears with the EPSON
logo.
5. Select [continue].
Execute the setup of the OS after the OS is recovered.
6. Resume [OPUS] and [UniMini] saved in “Creation of the recovery media” to the
[C:\Backup] directory.
CAUTION:
Saving the image data requires 500 to 600MB. 3GB capacity is required for Windows
2000. Therefore, select the CD-ROM, MO, Server or other media having a large
capacity for saving.
HD image data file (HDIMG002.PQI) cannot be partitioned due to the EasyRestore
limitation.
EasyRestore runs only on MS-DOS. Therefore, the saving device as described in “Saving
the HD image data” should be recognized by MS-DOS.
If the system is booted from the internal hard disk of the SR-600, it cannot be recovered.