Epson SR-600 - Manual (Page 73)

Rev.A Driver / Utility Specifications 4-3
Developer's Guide SR-600 Confidential
Network Driver
Installation
Follow the steps below to install the Driver for NT Network. Refere the Chapter 2 “OS and
Driver Setup” for other OS installation procedures.
1. Open the Control Panel and double click “Network”. The dialog shown below is displayed.
Click [Yes] button.
2. "Network Setup Wizard” starts. Select “Connect to the Network” check box and click [Next]
button.
3. Click [Select from the list] button.
4. Click [Use Disk] button.
5. Tyepe “C:backup\network” and click [OK] button.
6. Select “RTL8139(A/B/C/8130) PCI Fast Ethernet Adapter” and click [OK] button.
7. "RTL8139(A/B/C/8130) PCI Fast Ethernet Adapter” is added to the Network Adapter.
Click [Next] button.
8. Click the Network Protocol that you want to install, then click [Next] button.
9. Click the Network Service that you want to install, then click [Next] button.
10. Next dialog is displayed, then click [next] button. It starts installation.
11. Set the Duplex Mode. Select [(1)AUTO] , then click [Continue].
12. Reboot the system after the installation.