Eiki LC-SXIU - Manual (Page 12)

CONNECTING TO THE COMPUTER INPUT I TERMINAL (ANALOG HDB 15-PIN)
Personal computers can be connected to the HDB1 5-pin (VGA) terminal on the projector.
• Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
CAUTION: For projectors, the VGA cable provided is designed to reduce RFI (Radio Frequency Interference)
emissions. For regulatory compliance reasons, this cable must be used and must not be replaced by
any other cable.
CONNECTING TO THE COMPUTER INPUT I TERMINAL (DIGITAL MDR 20-PIN)
Digital output signal from the computer can be connected to the DIGITAL terminal (MDR 20-pin). When using this
input, Graphic Accelerator Board designed for this projector should be installed into your computer and set-up the
computer configuration following instruction included in the Graphic Accelerator Board package. Refer to DIGITAL
INPUT CONNECTION on page 15 and 17.
CONNECTING TO THE COMPUTER INPUT 2 JACKS (BNC x 5)
Personal computers can be connected to the computer input (Red, Green, Blue, Horiz. Sync. and Vert. Sync.) on
the projector.
• Connect the computer to these jacks using the BNC cables (not provided).
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (I and 2)
• Connect audio outputs from your computer to these jacks using the audio cable (not provided).
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (I and 2 )
• When the computer is operated by projectors remote control unit, connect three different type of cables
(provided) between projector control port and computer mouse port or serial port.
COMPUTER TYPE
IBM Compatible computer with PS/2 mouse port.
IBM Compatible computer with serial port.
Apple Machintosh computer with ADB mouse port.
.CABLE
. . .
Mouse Cable for PS/2 port.
Mouse Cable for Serial port.
Mouse Cable for ADB port.