Eiki LC-SXIU - Manual (Page 32)

TO TURN ON THE PROJECTOR
Connect the projector to a source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriate
terminals on the side of the projector (See CONNECTING THE PROJECTOR section on pages 10-21).
Connect the projectors AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the side of
the projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light GREEN.
Press the POWER ON/OFF button on the remote control unit or on the projector to
ON.
The LAMP POWER indicator light will dim and the cooling fans will operate. The wait
display appears on the screen and the count-down starts (30-29-28-,..1). The signal
from the source appears after 30 seconds.
CAUTION:
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU HAVE TURNED IT ON, WAIT AT LEAST 5
MINUTES BEFORE TURNING IT OFF.
NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continued to flash, follow the procedures below:
(1). Press POWER ON/OFF button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner (See “AIR FILTER CARE AND CLEANING” section on page 53.)
(4). Press POWER ON/OFF button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or
service station.
TO TURN OFF THE PROJECTOR
Press the POWER ON/OFF button on the remote control unit or on the projector.
The “Power off ?“ appears on the screen. Press again the POWER ON/OFF
button to turn OFF the projector. The LAMP POWER indicator will light bright and
READY indicator will turn off. The cooling fans will operate for 1 minute after the
projector is turned off. (During this “cooling down” period, the projector cannot be
turned on.) The READY indicator will light green again and the projector may be
turned on by pressing the POWER ON/OFF button. To power down completely,
turn the MAIN ON/OFF switch (located on the side of the projector) to the OFF
position.