Eiki LC-SXIU - Manual (Page 13)

CONNECTING TO THE MONITOR OUTPUT TERMINAL (ANALOG HDB 15.PIN)
This terminal output the information of the selected computer source being viewed on the screen (Computer 1 or
Computer 2).
When video source (“Video 1” or “Video 2) is selected, this terminal outputs Computer 1 input information.
An external monitor can be connected to the HDB15-pin (VGA) terminal on the projector.
• Connect the monitor to this terminal using the VGA cable (not provided).
Pin No./Signal Pin No/SignaI
1 Red input 9 Non Connect
2 Green input 10 Ground (Vert. sync.)
3 Blue input 11 Sense 0
4 Sense 2 12 Sense 1
5 Ground (Horiz.sync.) 13 Horiz. sync
6 Ground (Red) 14 Vert. sync
7 Ground (Green) 15 Reserved
8 Ground (Blue)
CONNECTING TO THE AUDIO MO ITOR OUTPUT (VAR ABLE) JACKS,
These jacks will contain the audio information of the selected program source being viewed on the screen (Computer
1,
Computer 2, Video 1 or Video 2). If you have selected program source Computer 2 the audio signal connected to the
Computer 2 audio input jack will be available at the audio monitor output jacks.
Use RCA type audio for connection.
• If the audio input of the audio equipment is stereo, be sure to connect the right and left channels to the respective
right and left jacks.
• If the audio input of the audio equipment is monaural, connect it to the left jack.
CONNECTING TO THE SERIAL PORT (DB –PIN) TERMINAL
• if you control the projector by computer, you must connect a cable (rot
provided) from your computer to this terminal.
CONNECTING TO THE USB PORT CONNECTORS (I and 2)
This Projector is designed for connecting with USB Port of the computer or peripheral equipment that is to be
standard.