Enterasys Networks A2H124-24FX - Manual (Page 17)

SecureStack A2 Installation Guide xv
About This Guide
This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys
®
SecureStack A2H124‐24FX stackable Ethernet switch.
For information about the Command Line Interface (CLI) set of commands used to
configure and manage the switch, refer to the Enterasys Networks
®
SecureStack A2
Configuration Guide.
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting
up the stackable switches.
Note: In this guide, the following terms are used:
• Switch refers to an A2H124-24FX unless otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form plugable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
Important Notice
Depending on the firmware version used in the A2H124-24FX switch, some features described in this
document may not be supported. Refer to the Release Notes shipped with the SecureStack A2 to
determine which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.