Management, Switch configuration using webview, Switch configuration using cli commands – Enterasys Networks A2H124-24FX User Manual
Page 25: Standards compatibility, Lanview diagnostic leds, Management -5, Standards compatibility -5 lanview diagnostic leds
Management
SecureStack A2 Installation Guide 1-5
Management
Management of the module can be either in‐band or out‐of‐band. In‐band remote
management is possible using Telnet, Enterasys Networks’ NetSight
®
management
application, or the WebView application. Out‐of‐band management is provided through
the DB9 Console port connector on the front panel using a VT100 terminal or a VT100
terminal emulator.
Switch Configuration Using WebView
Enterasys Networks’ HTTP‐based Web management application (WebView) is an
intuitive web tool for simple management tasks.
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete SecureStack A2 configuration
management tasks.
For CLI command set information and how to configure the module, refer to the
SecureStack A2 Configuration Guide.
Standards Compatibility
The A2H128‐24FX is fully compliant with the IEEE 802.3‐2002, 802.3ae‐2002, 802.1D‐1998,
and 802.1Q‐1998 standards. The SecureStack A2 provides IEEE 802.1D‐1998 Spanning
Tree Algorithm (STA) support to enhance the overall reliability of the network and
protect against “loop” conditions.
LANVIEW Diagnostic LEDs
LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an
easy way to observe the status of individual ports and overall network operations.