Enterasys Networks A2H124-24FX - Manual (Page 29)

SecureStack A2 Installation Guide 3-1
3
Hardware Installation
This chapter provides instructions to install the A2H124‐24FX. Follow the order of the
sections listed below to correctly install the switch.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the switch to check for any exceptions to the supported
features and operation documented in this guide.
For information about... Refer to page...
Considerations Prior to Installation 3-2
Required Tools 3-2
Unpacking the Switch 3-2
Installing Optional Mini-GBICs 3-3
Installing the Switch on a Flat Surface 3-7
Rack Mounting the Switch 3-10
Connecting Stacking Cables 3-11
Configuring Switches in a Stack 3-13
Connecting AC and RPS-SYS Power 3-16
Connecting to Console Port for Local Management 3-20
Connecting to the Network 3-24
Completing the Installation 3-33