Enterasys Networks A2H124-24FX - Manual (Page 46)

Connecting AC and RPS-SYS Power
3-18 Hardware Installation
C2RPS-SYS Redundant Power System
If you are installing an optional redundant power system (C2RPS‐SYS), refer to the
installation instructions supplied with the SecureStack RPS. The switch is connected to a
C2RPS‐PSM using a C2RPS‐PSM Cable.
Figure 3-10 Accessing the RPS Connector
If you are installing the switch as a standalone switch, proceed to “ Connecting to Console
Port for Local Management ” on page 3‐20. If you are installing switches in a stack
configuration, apply power to each switch in order, according to the procedure you use in
“
Configuring Switches in a Stack ” on page 3‐13.
1 RPS coverplate 3 Screw holes for coverplate
2 Retaining screws to fasten plate
Caution: To prevent damaging the switch, DO NOT connect a Power over
Ethernet-compliant Redundant Power System (C2RPS-POE) to the redundant power
supply connector. The switch is only compatible with the SecureStack C2RPS-SYS
redundant power supply system.
Precaución: No conecte una fuente de poder redundante (RPS) SecureStack PoE
(C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede dañarse.
MAC
ADD
RES
S
SER
IAL N
O.
AC L
INE 100-2
40 V
AC 50-6
0 Hz 1.4 A
MAX
.
Redu
ndan
t Pow
er S
upply
DC L
ine 1
2V /1
3A M
AX.
А
Б
Б
В
В