Enviro Cara - Manual (Page 27)

27
Figure 46: Installation for Rear Vented;
33,500 Btu/hr.
Place the unit into position.
Attach a small section of pipe on the unit and mark exterior
wall where vent would pass through the wall.
Cut a 10” (25.4 cm) minimum hole in the wall to maintain
clearances to combustibles. Frame hole as shown in Figure
32.
Install a wall thimble, interior finished collar, and the vent
section through the wall.
THIS UNIT MUST BE VENTED WITH A 36” (91 cm) SNORKEL
KIT.
Seal around the vent terminal to the structure using a non-
hardening mastic.
Also refer to I
nItIal
I
nstallatIon
- V
ent
C
onfIguratIons and
r
estrICtor
s
ettIngs
and I
nItIal
I
nstallatIon
- H
orIzontal
I
nstallatIon
.
Initial Installation
QUALIFIED INSTALLERS ONLY
c
onVerting
t
op
V
ented into
r
ear
V
ented
:
This unit has been shipped as a 33,500 Btu/hr top-vented freestanding unit. This unit can be converted
Figure 45: Converting Top Vented into Rear Vented.
i
nstallation of
r
ear
V
ented
a
ppliance
:
to a rear vented unit for use with a 36” (915
mm) snorkel. Also refer to I
nItIal
I
nstallatIon
- I
nstallatIon of
r
ear
V
ented
a
pplIanCe
.
1. Carefully remove the trivet and the
stovetop. Place on a soft surface as not to
damage the finish.
2. Remove the four (4) ¼” screws that hold
the flue collar elbow to the unit body.
3. Carefully remove the elbow being sure not
to damage the gasket that is glued to the
flue collar elbow, it seals the flue to the
firebox (see Figure 42).
4. Turn the elbow 180° to the rear vent
position and re-fasten with the screws
removed in step 2.