Enviro Cara - Manual (Page 34)

Figure 55: Log Placement of Right Log.
The placement of the logs is not arbitrary. If
they are positioned incorrectly, the flames
can be “pinched” and will not burn correctly.
The burner has four (4) pins and four (4)
ledges which make alignment easier. Using
the pictures provided, carefully set the logs
in place.
NOTE: The logs are fragile and should
be handled gently.
1. Carefully remove logs from box and
check there is no damage. It is very
important to install all logs in their
proper position to ensure safe, optimum
operating conditions.
2. Place the Left Rear Log Chunk on the
two (2) left rear pins and the Right Rear
Log Chunk on the two (2) right rear pins
(refer to Figures 53 and 54).
3. Place the bottom of the “Y” Log in the
ledge at the front left of the burner and
the top of the log rests on the Right
Rear Log Chunk as shown in Figure 54
and 55.
4. Place the bottom of the Right Log in the
ledge at the front right of the burner and
rest the top of the log against the rear
panel as shown in Figure 55 and 56.
Secondary Installation
I
nstallatIon of
l
og
s
et
:
Figure 53: Log Placement of Rear Log Chunks.
Figure 54: Log Placement of “Y” Log.
34