Envision Peripherals EN-8500 - Manual (Page 26)

EN-8500
25
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected , If the connector is
loose, tighten the connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode ,Set the computer to
display mode given in the following table.
VIDEO/TV NO SIGNAL :
You set the monitor to the VIDEO /TV mode but there is no video/TV signal
input. Check to make sure that the video/TV signal cable is properly
connected and make sure the video player is working.
If the monitor is stuck in “Power Saving” mode:
1. Make sure monitor’s signal-cable is properly connected to the computer.
2. The computer has switched the monitor into power save mode. Press
any key on the computer keyboard to wake up the monitor.
3. Check that the computer is switched on.
4. Check the computer resolution, rate may be too high and out of the LCD-
MONITOR’s display mode range.
RESOLUTION :
RESOLUTION
VERTICAL
FREQUENCY
RESOLUTION
VERTICAL
FREQUENCY
640 × 480 60Hz 800 × 600 60.3Hz
640 × 350 70Hz 800 × 600 72.2Hz
720 × 400 70Hz 800 × 600 75Hz
640 × 480 72.8Hz 832 × 624 74.5Hz
640 × 480 75Hz 1024 × 768 60Hz
640 × 480 66.67Hz 1024 × 768 70Hz
800 × 600 56.3Hz 1024 × 768 75Hz
1024 × 768 74.92Hz
ERROR MESSAGE & POSSIBLE SOLUTION