Kichler 43641 User Manual

We’re here to help

Advertising

CHAIN DROP INSTALLATION INSTRUCTIONS

1) Pass threaded pipe on end of small loop up through hole in
canopy.
2) Thread lockwasher onto end of threaded pipe protruding

from inside canopy.

3) Thread hexnut onto end of threaded pipe protruding from

inside canopy. Tighten hexnut to secure small loop to canopy.

4) Pass fixture wire from top of fixture through hole in bottom

of large loop. Thread large loop onto threaded pipe on top of

fixture.
5) Attach one end of chain to large loop on top of fixture.

Attach other end of chain to small loop on canopy.

6) Weave fixture wires through chain links no more than 3

inches apart.

7) Pass fixture wires through hole in small loop on canopy and

up through hole in canopy.

8) TURN OFF POWER.

IMPORTANT: Before you start, NEVER attempt any work

without shutting off the electricity until the work is done.

a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF”

position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room

that you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the “OFF” position.

9) Find the appropriate threaded holes on mounting strap.

Assemble mounting screws into threaded holes.

10) Attach mounting strap to outlet box. (Screws not provided).

Mounting strap can be adjusted to suit position of fixture.

11) Grounding instructions: (See Illus. A or B).

A) On fixtures where mounting strap is provided with a

hole and two raised dimples. Wrap ground wire from

outlet box around green ground screw, and thread into

hole.

B) On fixtures where a cupped washer is provided. Attach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounting strap.

If fixture is provided with ground wire. Connect fixture

ground wire to outlet box ground wire with wire connector

(not provided.) after following the above steps. Never

connect ground wire to black or white power supply wires.

12) Make wire connections (connectors not provided). Reference

chart below for correct connections and wire accordingly.

13) Push fixture to ceiling, carefully passing mounting screws

through holes in canopy.

14) Thread knurl knobs onto mounting screws. Tighten knurl

knobs to secure fixture to ceiling.

15) Thread end of threaded pipe with bead into hole in bottom

of socket cluster.

16) Pass hole in flat washer over end of threaded pipe. Pass

hole in rubber washer over end of threaded pipe.

17) Raise glass up to fixture. Pass hole in glass over end of

threaded pipe.

18) Pass hole in rubber washer over end of threaded pipe

protruding from bottom of glass. Pass hole in flat washer

over end of threaded pipe. (DO NOT over tighten.)

MOUNTING STRAP

ABRAZADERA DE MONTAJE

LARGE CANOPY

ESCUDETE GRANDE

Date Issued: 8/29/14

IS-43641-US

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

(NOT PROVIDED)

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.

KNURL KNOB

PERILLA ESTRADA

SMALL LOOP

ANILLO PEQUEÑA

CHAIN

CADENA