Kichler 43567 User Manual

Kichler Lighting

Advertising

1) TURN OFF POWER.

IMPORTANT: Before you start, NEVER attempt any work

without shutting off the electricity until the work is done.

a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF”

position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room

that you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the “OFF” position.

2) Find the appropriate threaded holes on mounting strap.

Assemble mounting screws into threaded holes.

3) Attach mounting strap to outlet box. (Screws not provided).

Mounting strap can be adjusted to suit position of fixture.

4) Grounding instructions: (See Illus. A or B).

A) On fixtures where mounting strap is provided with a

hole and two raised dimples. Wrap ground wire from

outlet box around green ground screw, and thread into

hole.

B) On fixtures where a cupped washer is provided. Attach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounting strap.

If fixture is provided with ground wire. Connect fixture

ground wire to outlet box ground wire with wire connector

(not provided.) after following the above steps. Never

connect ground wire to black or white power supply wires.

5) Make wire connections (connectors not provided). Reference

chart below for correct connections and wire accordingly.

6) Push fixture to ceiling, carefully passing mounting screws

through holes in canopy.

7) Thread knurl knobs onto mounting screws. Tighten knurl

knobs to secure fixture to ceiling.

8) Thread end of threaded pipe with hexnut into hole in bottom

of socket cluster.

9) Screw hexnut onto end of threaded pipe.
10) Pass hole in flat washer over end of threaded pipe. Pass

hole in rubber washer over end of threaded pipe.

11) Raise shade up to fixture. Fit shade over socket cluster.
12) Raise glass diffuser up to fixture. Pass hole in glass diffuser

over end of threaded pipe. Fit glass diffuser up against

bracket on bottom of shade.

13) Pass hole in rubber washer over end of threaded pipe

protruding from bottom of glass. Pass hole in flat washer

over end of threaded pipe. (DO NOT over tighten.)

14) Thread hexnut onto end of threaded pipe.
15) Pass hole in bottom trim over end of threaded pipe. Thread

finial onto end of threaded pipe. (DO NOT over tighten.)

16) Attach crystal to loop on bottom of finial.

Date Issued: 9/19/14

IS-43567-US

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

(NOT PROVIDED)

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.