Kichler 45133 User Manual

We’re here to help

Advertising

1) TURN OFF POWER.

IMPORTANT: Before you start, NEVER attempt any work

without shutting off the electricity until the work is done.

a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF”

position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room

that you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the “OFF” position.

2) Find the appropriate threaded holes on mounting strap.

Assemble mounting screws into threaded holes.

3) Attach mounting strap to outlet box.
4) Grounding instructions: (See Illus. A or B).

A) On fixtures where mounting strap is provided with a hole

and two raise dimples. Wrap ground wire from outlet

box around green ground screw, and thread into hole.

B) On fixtures where a cupped washer is provided. Attach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounting strap.

If fixture is provided with ground wire. Connect fixture

ground wire to outlet box ground wire with wire connector.

(Not provided.) After following the above steps. Never connect

ground wire to black or white power supply wires.

5) Make wire connections (connectors not provided.) Reference

chart below for correct connections and wire accordingly.

6) Push fixture to wall. Place canopy of fixture over tabs on
mounting bracket.
NOTE: Be certain wires do not get pinched between canopy
and mounting strap.
7) Thread one screw into hole on top and bottom of canopy.
Tighten screws to secure fixture in place.
8) Insert recommended bulb.
9) Carefully set glass down inside cage. Press bracket on cage

down against inside of glass.

10) Raise cage with glass up to fixture. Pass threaded studs on

cage up through holes in roof of fixture.

11) Screw threaded caps onto threaded studs. Tighten threaded

caps to secure cage to fixture. (DO NOT over tighten.)

Date Issued: 10/31/14

IS-45133-US

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

(NOT PROVIDED)

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

Connect Black or

Red Supply Wire to:

Connect

White Supply Wire to:

Black

White

*Parallel cord (round & smooth)

*Parallel cord (square & ridged)

Clear, Brown, Gold or Black

without tracer

Clear, Brown, Gold or Black

with tracer

Insulated wire (other than green)

with copper conductor

Insulated wire (other than green)

with silver conductor

*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)

Neutral Wire