Kichler 43573 User Manual

Kichler Lighting

Advertising

1) Lower glass down into cage. Align holes along top of glass

with holes along top edge of cage.

2) Lower top cap with sockets down toward glass and cage.

Pass socket down through top of glass. Fit edge of top cap

inside glass. Align holes along edge of top cap with holes in

glass and cage.

3) Thread one thumbscrew into each hole along edge of cap

and into holes in cage and glass. IMPORTANT: Insert each

thumbscrew into holes in cap. DO NOT fully tighten each

thumbscrew until all thumbscrews are in place. Once all

thumbscrews are in place, fully tighten each thumbscrew to

secure cap to cage and glass.

4) Pass fixture wire from coupling on top cap through center
tube.
5) Screw center tube onto coupling on top cap.
6) Pass wire from center tube through stem and screw stem to

top of center tube. NOTE: Thread locking compound must be

applied to all stem threads as noted with symbol (3) to

prevent accidental rotation of fixture during cleaning,

relamping, etc.

7) Pass fixture wire through remaining stems and screw stems
together.
8) Pass fixture wire through first loop. Thread first loop onto

end of last stem.

9) Pass fixture wire through second loop and through hole in
canopy.
10) Pass threaded pipe at end of second loop through hole in
canopy.
11) Pass fixture wire through hole in lockwasher. Thread

lockwasher onto end of threaded pipe protruding from

inside canopy.

12) Pass fixture wire through hole in hexnut. Thread hexnut onto

end of threaded pipe.

13) Attach chain link to small loop at end of stem and to loop on
canopy.
14) TURN OFF POWER.

IMPORTANT: Before you start, NEVER attempt any work

without shutting off the electricity until the work is done.

a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF”

position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room

that you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the “OFF” position.

15) Find the appropriate threaded holes on mounting strap.

Assemble mounting screws into threaded holes.

16) Attach mounting strap to outlet box. (Screws not provided).

Mounting strap can be adjusted to suit position of fixture.

17) Grounding instructions: (See Illus. A or B).

A) On fixtures where mounting strap is provided with a

hole and two raised dimples. Wrap ground wire from

outlet box around green ground screw, and thread into

hole.

B) On fixtures where a cupped washer is provided. Attach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounting strap.

If fixture is provided with ground wire. Connect fixture

ground wire to outlet box ground wire with wire connector

(not provided.) after following the above steps. Never

connect ground wire to black or white power supply wires.

MOUNTING STRAP

ABRAZADERA DE MONTAJE

CANOPY

ESCUDETE

Date Issued: 9/26/14

IS-43573-US

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

(NOT PROVIDED)

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.

KNURL KNOB

PERILLA ESTRADA

SMALL LOOP

ARGOLLA PEQUEÑA

CHAIN LINK

ESLABÓN DE CADENA

STEM

VASTAGO