Kichler 49600 User Manual

We’re here to help

Advertising

1) TURN OFF POWER.

IMPORTANT: Before you start, NEVER attempt any work

without shutting off the electricity until the work is done.

a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF”

position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room

that you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the “OFF” position.

2) Find the appropriate threaded holes on mounting strap.

Assemble mounting screws into threaded holes.

3) Attach mounting strap to outlet box. (Screws not provided).

Mounting strap can be adjusted to suit position of fixture.

4) Grounding instructions: (See Illus. A or B).

A) On fixtures where mounting strap is provided with a hole

and two raise dimples. Wrap ground wire from outlet

box around green ground screw, and thread into hole.

B) On fixtures where a cupped washer is provided. Attach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounting strap.

If fixture is provided with ground wire. Connect fixture

ground wire to outlet box ground wire with wire connector.

(Not provided.) After following the above steps. Never connect

ground wire to black or white power supply wires.

5) Make wire connections (connectors not provided.) Reference

chart below for correct connections and wire accordingly.

6) Push fixture to wall, carefully passing mounting screws

through holes in fixture.

7) Screw threaded balls onto mounting screws. Tighten

threaded balls to secure fixture to wall.

8) Insert recommended bulbs.
9) Raise glass up to fixture. Pass hole in top of glass over

threaded pipe on bottom of socket cluster.

10) Fit glass inside top of cage on fixture. Pass hole in bottom of

glass over end of threaded pipe on bottom of socket cluster.

11) Pass hole in rubber washer over end of threaded pipe

protruding from bottom of glass. Pass hole in flat washer

over end of threaded pipe. Screw hexnut onto end of

threaded pipe. (DO NOT over tighten.)

12) Raise bottom of cage up to fixture. Fit bottom of cage over

glass. Pass hole in bottom of cage over end of threaded

pipe protruding from bottom of glass.

13) Thread hex coupling onto end of threaded pipe protruding

from bottom of cage.

14) Thread end of short threaded pipe into hex coupling

protruding from bottom of cage.

15) Pass hole in bottom trim over end of short threaded pipe.
16) Thread finial onto end of short threaded pipe. Tighten finial

to secure cage in place.

Date Issued: 1/2/15

IS-49600-US

MOUNTING STRAP

PLANCHA PARA

MONTAR

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

(NOT PROVIDED)

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

Connect Black or

Red Supply Wire to:

Connect

White Supply Wire to:

Black

White

*Parallel cord (round & smooth)

*Parallel cord (square & ridged)

Clear, Brown, Gold or Black

without tracer

Clear, Brown, Gold or Black

with tracer

Insulated wire (other than green)

with copper conductor

Insulated wire (other than green)

with silver conductor

*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)

Neutral Wire

SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.

THREADED BALL

BOLA ROSCADO