Epson TOUCH DH200 - Manual (Page 32)

22
Using the Main Menu
DISPLAY
Use the Display menu to configure
the OSD and Auto Sequence
settings.
To change display settings:
1. Select the DISPLAY SETUP tab, and
configure the following:
• STATUS BAR: Select to Show or Hide the
status bar on the OSD.
• CAMERA: Select to show the CAMERA NO. or
the CAMERA TITLE or both.
• BORDER LINE: Set the color for the borders
of the OSD: WHITE, BLACK, DARK GREY, or
GREY
• BACKGROUND: Set the background color for
disconnected cameras on the main display:
GRAY, WHITE, BLUE, or DARK GREY
• SPLIT MODE: Set up to four split-screen
display modes
• QUICK SETUP : Select ON/OFF to enable/disable
the quick setup menu
2. Press ENTER to save your changes and
exit.
Sequential Setup
Configure Sequential Setup (Auto Sequence)
settings.
To configure Sequential Setup settings:
1. Select the SEQUENTIAL SETUP tab and
configure the following:
• DWELL TIME: Set from 1~30 seconds.
• SEQ. MODE: Set the display mode, from single
channel full-screen to 8-channel
split-screen
NOTE: You must select one of these
display modes to enable Auto Sequence
mode. If none of these modes are
selected, Auto Sequence
will not begin.
• FULL SCREEN: Select channels for
full-screen display. If selected, these
channels will appear in full-screen during
Auto Sequence mode
2. Press the ENTER button to save your
settings and enable Auto Sequence. Auto
Sequence will immediately begin.
3. Press the DISPLAY button to stop Auto
Sequence.
Auto Sequence with Front Panel and
Remote Control
Once you have configured the Auto Sequence
settings in the Display menu, you can use the
remote control to turn Auto Sequence on/off.
To enable/disable Auto Sequence:
1. Press and hold on the front panel or
remote control for 2 seconds.
2. To exit press . The main screen will
return to a quad display.
Figure 12.0 Display menu
Figure 12.1 Auto Sequence setup