Epson TOUCH DH200 - Manual (Page 72)

62
Remote Setup
RECORD
To configure continuous recording options:
1. Select a camera.
NOTE: Number of displayed cameras depends
on model number of your system.
2. For each camera configure the following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
NOTE: The system will automatically reset
if you enable/disable any cameras.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. Audio capable
cameras or microphones are required for
audio recording.
• MOTION: Select ON/OFF. If Motion is set to
ON, the system will only record from the
selected camera when motion is detected.
NOTE: Motion Grid and sensitivity must be
configured in the Motion menu. See “MOTION”
on page 61.
3. Click APPLY and then OK to save your
changes and close the window.
ALARM
To configure alarm settings:
1. Under RECORD SETUP, configure the
following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. The number of audio
input channels varies by model.
• INPUT: Select N.O/N.C.
2. Under ALARM SETUP, configure the
following:
• RECORD TIME: Set from 10~300 seconds (in
increments of 10 seconds).
• RECORD CAMERA: Select ALL or 1:1. If you
select ALL, the system will record on all
channels; if you select 1:1, the system will
only record for the designated channel
• ALARM BUZZER: Select ON/OFF . If ON, the
system will sound a beep when the external
alarm is triggered
3. ALARM OUT1 : Set the type of Alarm Out video
(external monitor required, not included).
Select SYSTEM, VIDEO LOSS, MOTION, ALL
ALARM, or ALARM IN1~8, and then select ON/
OFF
4. Click APPLY and then OK to save your
settings and close the window.
Figure 35.0 Record options Figure 36.0 Alarm options