Note: daily has priority over a weekly schedule, Figure 37.0 schedule options, Figure 37.1 mode tab options – Epson TOUCH DH200 User Manual
Page 73: Rate: select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps, Audio: select on/off. audio channels vary by model, Motion: select on/off, Figure 37.2 daily schedule input, Schedule
63
Remote Setup
SCHEDULE
NOTE:
Daily has priority over a Weekly
schedule.
To set a recording schedule:
1. Select MODE1 (red), MODE2 (orange),
MODE3 (green), or MODE4 (blue) and
configure the following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. Audio channels vary
by model.
• MOTION: Select ON/OFF
2. Select the CHART tab and select ALL,
SUN, MON, TUE, WED, THU, FRI, or SAT.
The Schedule sub-menu opens.
3. Enter BEGIN and END times, and select
the MODE for ten time slots and click OK.
4. Click APPLY and then OK to save your
settings and close the window.
NOTE: You must enable scheduled recording
directly on your system. DVR NetView will only
let you edit and configure the recording
schedule(s).
NOTE: For an example on setting a recording
schedule, see “Overnight Recording” on
page 26.
Figure 37.0 Schedule options
Figure 37.1 Mode tab options
Figure 37.2 Daily schedule input