Epson TOUCH DH200 - Manual (Page 70)

60
Remote Setup
DISPLAY
To configure Display options:
1. Under the DISPLAY SETUP tab, configure
the following:
• STATUS BAR: Select to Show or Hide the
status bar on the OSD.
• CAMERA: Select to show the CAMERA NO. or
the CAMERA TITLE or both.
• BORDER LINE: Set the color for the borders
of the OSD: WHITE, BLACK, DARK GREY, or
GREY
• BACKGROUND: Set the background color for
disconnected cameras on the main display:
GRAY, WHITE, BLUE, or DARK GREY
2. Click APPLY and then OK to save your
settings and close the window.
Sequential Setup (Auto
Sequence)
To enable sequential setup:
1. Under the SEQUENTIAL SETUP tab,
configure the following:
• DWELL TIME: Set from 1~30 seconds.
• SEQUENTIAL MODE: Set the display mode,
from single channel full-screen to 8-channel
split-screen
NOTE: You must select one of these display
modes to enable Auto Sequence mode. If
none of these modes are selected, Auto
Sequence
will not begin.
• FULL SCREEN MODE: Select channels for
full-screen display. If selected, these
channels will appear in full-screen during
Auto Sequence mode
2. Click APPLY and then OK to save your
settings and close the window.
With at least one Sequential Mode option
selected, Auto Sequence will begin on the DVR
only.
To disable sequential setup:
1. Deselect all options under Sequential
Mode.
2. Click APPLY and then OK to save your
settings and close the window.
Figure 32.0 Display options
Figure 32.1 Sequential Setup