Consumer, Assembly / pre-operation – Electrolux OHV User Manual
Page 10
10
11
CONSUMER
ASSEMBLY / PRE-OPERATION
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 9 and 10)
1. Install remote cable bracket to discharge chute with
5/16-18 carriage bolt, flat washer and 5/16-18 locknut
as shown. Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and
1/4-20 locknut as shown. Tighten securely.
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown.
INSTALL WEIGHT BAG (See Fig. 11)
Though seldom required, the weight bag will reduce the
tendency of the auger housing to ride up on hard, icy drifts.
Should conditions require it, install as follows:
1. Shut off engine and wait for all moving parts to stop.
2. Fill weight bag with desired amount of sand.
3. Place weight bag on top of auger housing with mount-
ing clamp at front edge of auger housing as shown.
IMPORTANT: Mount the weight bag in a location which
does not cover the warning decals on top of the auger
housing.
CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated at the fac-
tory for shipping purposes. Correct and equal tire pressure
is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI.
WEIGHT
BAG
5/16-18 x 1-1/2
CAPSCREWS
BAR
AUGER HOUSING
MOUNTING
CLAMP
FIG. 11
CHUTE DEFLECTOR
CONTROL LEVER
FIG. 10
HOOK BETWEEN
HEX NUTS
ON CHUTE RO-
TATER HEAD
SPRING
CHUTE DE-
FLECTOR
5/16-18
CARRIAGE
BOLT
5/16-18 LOCK-
NUT
REMOTE
CABLE
BRACKET
1/4-20
LOCK-
NUT
FLAT
WASHER
CABLE EYE-
LET
NYLON
WASHER
1/4-20
SHOULDER
BOLT
FIG. 9
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com