Electrolux OHV User Manual
Page 36
36
37
7.32 Replace Auger Belt
1) Remove spark plug wire from plug.
2) Remove Chute Assy. See section 7.51
3) Remove both 3/8
"
screws that secure belt
cover. Remove belt cover.
4) Place a chair or saw horse under handle for
support after auger section is split.
5) Remove both 9/16
"
hex bolts that hold the
powerhead and auger housing together.
6) Remove belt from drive pulley as you
separate the auger from the powerhead
assembly
7) Place new belt on auger pulley.
8) Lift auger housing into position and ensure
that slotted bracket on auger housing are
placed onto the rod at base of powerhead
10)Reinstall bolts to secure auger housing to
the powerhead.
11)Reinstall the belt cover and the chute
assembly. ( See Section 7.51)
9) Route auger belt around pulleys, checking
that the belt does not catch on idler brkt.
ROD
SLOTTED
BRACKET
LEFT BOLT
RIGHT BOLT
BELT COVER
RIGHT SCREW
AUGER BELT
IDLER PULLEY
AUGER BELT
IDLER PULLEY
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com